Cs810 V Clamp Lever z1800 4 of these are fitted

4 of these are fitted to the underside of the sliding table on the CS88 and Cs89

Spacer bars are placed between the back of very low mouldings and your underpinner back fences in order to give adequate clearance for the clamping pad to make good contact with the top of the moulding

Cassese 810

*Tip: Measure the height of the height stop collar fitted to your worn out assembly before transferring it to this new assembly to ensure correct spacing

A spare pair should be kept at all times as the belts get sliced / cut by the moulding off cuts

Cs810 V Clamp Lever z1800 4 of these are fittedSteel lever that locks the Cs810 vertical clamp shaft in the down position. *only fits the Cs810 model